Toshiba 3511, 4511 manual 2nd transfer roller, 2nd transfer unit

[I] 2nd transfer roller

(1)Open the 2nd transfer unit.

(2)Release 4 latches and take off the cover.

Cover

Fig. 14-737

14

(3)Remove 1 clip. Take off the 2nd transfer roller while pushing the shaft.

(4)Remove each part from the 2nd transfer roller in order.

Notes: 1. When assembling, pay attention to the direction of the collar-2.

2.After assembling, check if the bushing-1, bearing and collar-2 slide smoothly along the axis of the shaft.

[J]2nd transfer unit

(1)Take off the ADU ( Chapter 17.5 [A]).

(2)Take off the bypass unit ( Chapter 10.4 [A]).

(3)Take off the right rear cover ( Chapter 2.5.1 [L]).

(4)Remove 2 clips and 1 spring, and then take off the slide hinge on the front side.

Clip

2nd transfer

roller

Fig. 14-738

Clip

Bearing

Collar-1 Bushing-2

Bushing-1

Bearing Washer

Washer Collor-2

Collor-3
Spring	Collar-1
Fig. 14-739
Slide hinge
Spring
Clip
Fig. 14-740

e-STUDIO3511/4511 TRANSFER/TRANSPORT UNIT 14 - 16 November 2003 © TOSHIBA TEC

04/10