Toshiba 3511, 4511 manual Cleaner unit

(6)Disconnect 2 connectors. Remove 3 screws and washer and pull out the cleaner unit.

Washer

Cleaner unit

Fig. 11-705

11

Notes: 1. When pulling out the drum cleaner unit, pull out straightly without leaning.

2.When pulling out the drum cleaner, check whether color developer is taking the regular position (the position where color toner cartridge can be pulled out from the front) or not. If it is not taking the regular position, rotate the revolver unit to the regular position.

3.If the transfer belt drive gear is not prop- erly engaged, take off the receiving tray, and then press the unit down until the unit is securely fixed (as shown in the figure at right) to engage the transfer belt drive gear.

4.If the transfer belt drive gear is not prop- erly engaged, the hole positions of the fixing screw (as shown in the figure at right) may not match. In this case, oper- ate the main motor for approx. 1 second in the Test Mode (03-101) to engage the drive gear securely and then install the unit.

Fig. 11-706

Fig. 11-707

e-STUDIO3511/4511 DRUM RELATED SECTION 11 - 10 November 2003 © TOSHIBA TEC

04/05