Toshiba 3511, 4511 manual Registration roller

10

(3)Disconnect 1 connector and remove 1 screw. Then take off the upper drawer feed sensor with the whole bracket.

(4)Disconnect 1 connector and remove 1 screw. Then take off the registration sensor with the whole bracket.

[D] Registration roller

(1)Take off the front right cover ( Chapter 2.5.1 [E]).

(2)Take off the transport motor drive unit ( Chapter 9.5 [B]).

(3)Remove 1 clip and take off the knob.

(4)Remove 1 screw and take off the bracket.

(5)Remove 1 clip and 1 bushing on each front/ rear side. Take off the registration roller (rubber roller) by sliding it to the rear side.

(6)Remove 1 clip, 1 bushing and 1 spring on each front/rear side. Take off the registration roller

(metal roller) by sliding it to the rear side. Note: The spring on the front side differs from the

one on the rear side. Note that the spring on the rear side has a black marking. So when installing, be careful not to mix them up.

Upper drawer feed sensor

Registration sensor

Fig. 10-429

Bracket

Fig. 10-430

Clip (6)	Clip (5)
Spring
(6)
Registration roller	Registration roller
(Metal roller)	(Rubber roller)
Fig. 10-431

Clip (5)	Clip (6)
Registration roller
(rubber roller)
	Spring (6)
	Registration roller
	(metal roller)
	Fig. 10-432

e-STUDIO3511/4511 PAPER FEEDING SYSTEM 10 - 18 November 2003 © TOSHIBA TEC