Toshiba 3511, 4511 manual Lens unit, Scan motor

6

[F] Lens unit

(1)Remove the lens cover ( Chapter 6.7 [B]).

(2)Disconnect 1 connector and remove 5 screws. Then remove 2 screws and 2 ground wires and take off the lens unit.

Notes: 1. When installing the lens unit, fix it while pushing it to the direction of the white arrow.

2.For adjustment, refer to “3.9.2 Lens Unit” in the Service Handbook.

3.Do not touch 4 screws shown with the arrows when replacing the lens unit.

4.Handle the unit with care. Do not touch the adjusted area and lens. (Hold the unit as the right figure.)

Ground

wire

Lens unit

Fig. 6-708

	Fig. 6-709
[Rear side]
	Lens
Adjusted area	[Front side]
	Fig. 6-710

[G] Scan motor				Connector
(1)	Take off the upper rear cover (		Chapter 2.5.1
	[Q]).
(2)	Take off the rear cover (	Chapter 2.5.1		[P]).
(3)	Disconnect 1 connector.
				Scan motor
				Fig. 6-711

e-STUDIO3511/4511 SCANNER 6 - 18 November 2003 © TOSHIBA TEC