Toshiba 4511, 3511 manual Lower transport clutch Low/High speed, Registration guide

[G]Lower transport clutch (Low/High speed)

(1) Take off the tray drive unit ( Chapter 10.4 [F]).

(2) Remove 4 screws and take off the bracket.

(3)Remove 3 screws and 1 E-ring. Then take off the clutch fixing bracket.

(4)Take off the lower transport clutch (low speed) and the lower transport clutch (high speed).

Notes: 1. Do not push the transport roller shaft strongly when installing the clutch fixing bracket and tighten the screws in the order of (a), (b) and (c). When the installation is finished, open the side cover and check if the transport roller rotates smoothly.

2.Attach the clutch to the shaft referring to the figure on the right.

[H] Registration guide

(1)Pull out the registration guide by holding its tab on the front side.

(2)Clean the paper dust removal brush attached on the registration guide.

Note: When taking off the registration guide, pay attention not to drop the removed paper dust from the brush into the inside of the equipment.

Bracket

Fig. 10-449

Lower transport clutch (Low speed)

Bracket

(b)
E-ring
(a)	Lower transport
	clutch (High speed)

Fig. 10-450

Clutch

Shaft

0-0.5mm

Fig. 10-451

Registration guide

Fig. 10-452

10

November 2003 © TOSHIBA TEC 10 - 23 e-STUDIO3511/4511 PAPER FEEDING SYSTEM