Toshiba 4511, 3511 manual Disassembly and Replacement, Bypass unit A-1 Bypass unit

10.4 Disassembly and Replacement

[A]Bypass unit (A-1) Bypass unit

(1) Take off the right front/rear hinge covers ( Chapter 2.5.1 [N] [O]).

(2) Disconnect 1 connector, remove 1 screw of ground wire and release the harnesses from the harness clamps (2 pcs.).

(3)Open the bypass feed tray. Remove 1 screw and take off the bypass feed front cover.

(4)Remove 1 screw and take off the bypass feed rear cover.

(5)Remove 3 screws. Lift up the bypass unit and take it off toward you.

Note: When installing the bypass unit, make sure that the ADU is closed in advance since the bypass unit occasionally does not slide smoothly.

Connector

Fig. 10-401

10

Fig. 10-402

Fig. 10-403

Fig. 10-404

November 2003 © TOSHIBA TEC 10 - 11 e-STUDIO3511/4511 PAPER FEEDING SYSTEM