Toshiba 3511, 4511 manual Transfer belt

4.If the transfer belt drive gear is not properly engaged, the hole positions of the fixing screw (as shown in the figure at right) may not match. In this case, operate the main motor for approx. 1 second in the Test Mode (03-101) to engage the drive gear securely and then install the unit.

[B]Transfer belt

Note: Wearing gloves is recommended to avoid direct touch by bare hands to the transfer belt surface.

(1)Take off the transfer belt unit ( Chapter 14.7 [A]).

(2)Remove 2 clips and take off the shaft by sliding

it to the rear side.

Note: When installing the shaft, insert the narrow part of the shaft into the stay on the rear side and fit it into the front side by sliding it.

Fig. 14-708

Fig. 14-709

(3) Remove 1 screw and 2 stand plates.

14

Stand plate (long)

Stand plate (short)

Fig. 14-710

e-STUDIO3511/4511 TRANSFER/TRANSPORT UNIT 14 - 8 November 2003 © TOSHIBA TEC

04/05