Toshiba 4511, 3511 manual Pressure roller, Thermostat

[H] Pressure roller

(1)Take off the fuser belt unit ( Chapter 16.7 [F]).

(2)Take off the separation finger unit ( Chapter 16.7 [G]).

(3)Take off the pressure roller.

(4)Remove each 1 ring, 1 bearing and 1 bushing on both front and rear sides of the pressure roller.

[I] Thermostat

(1)Take off the fuser unit ( Chapter 16.7 [A]).

(2)Remove 2 screws. Lift up the cleaning unit and

take it off.

Note: When installing, fit 2 protrusions on the bottom of the cleaning unit into the holes of the frame securely.

(3)Release the harnesses from the harness clamps.

(4)Remove 2 screws and take off the thermostat

unit.

Note: Be careful not to scratch the fuser belt.

Pressure roller

Fig. 16-729

Pressure roller

Bushing

Bearing

Ring

Fig. 16-730

Cleaning unit

Fig. 16-731

Thermostat unit

Fuser belt

Fig. 16-732

16

November 2003 © TOSHIBA TEC 16 - 23 e-STUDIO3511/4511 FUSER UNIT/PAPER EXIT SECTION