Toshiba 3511 Black developer lifting unit, Take off the black developer toner supply unit .7 K

[C] Black developer lifting unit

(1)Take off the black developer toner supply unit ( Chapter 11.7 [K]).

(2)Remove the harnesses from 5 harness clamps. Disconnect 3 connectors and remove 2 screws

and 2 springs. Take off the black developer lifting unit.

Note: The springs on both front and rear sides differ in the active coils (length of spring). When installing, pay attention to its active coils (length of spring).

Front side: 20 (longer)

Rear side: 18 (shorter)

(3)Disconnect 1 connector and release the latches. Then take off the black developer contact timing detection sensor.

12

(4)Remove 1 screw and disconnect 1 connector. Then take off the black developer contact position detection sensor with the whole bracket.

Spring

Spring

Fig. 12-832

Black developer contact timing detection sensor

Fig. 12-833

Black developer contact position detection sensor

Fig. 12-834

e-STUDIO3511/4511 DEVELOPER UNIT 12 - 24 November 2003 © TOSHIBA TEC