Toshiba 4511, 3511 manual Cleaning roller, Rear side

(4)Remove spring (B) on each end of the oil roller.

(5)Take off the oil roller.

(6)Remove 1 bushing from each side of the oil roller.

Note: Install the oil roller according to the marking on the frame (the shaft end with a groove should point at the rear side).

[C] Cleaning roller

(1)Take off the oil roller from the cleaning unit ( Chapter 16.7 [B]).

(2)Remove 1 E-ring and 1 bushing from the cleaning roller front side. Then take off the cleaning roller.

(3)Remove the spring (A) on each end of the

frame.

Note: When installing, make sure that the oil roller rotates smoothly by turning the gear (C) of the cleaning roller manually for a several times.

- Front side -

Spring (B)

Oil roller

- Rear side -

Fig. 16-705

Bushing

Fig. 16-706

	Groove
	Fig. 16-707
Cleaning roller	Gear (C)
E-ring
	Spring (A)
Bushing
	Fig. 16-708

16

November 2003 © TOSHIBA TEC 16 - 17 e-STUDIO3511/4511 FUSER UNIT/PAPER EXIT SECTION