Toshiba 4511, 3511 manual Exit sensor / Exit finger / Transport guide

(4) Remove each 1 screw and take off the thermistor from each bracket.

Note: When installing, be careful not to deform the thermistor or the frame (plate). Also, make sure that the thermistor is in touch with the fuser belt.

[K]Exit sensor / Exit finger / Transport guide

(1) Take off the fuser unit ( Chapter 16.7 [A]).

(2) Open the jam access cover and transport guide.

(3) Remove 3 screws and take off the cover (A).

Fig. 16-737

Cover (A)

(4)Remove 1 screw and plate spring.

(5)Disconnect 1 connector and take off the exit sensor.

(6)Remove 1 spring.

(7)Remove 1 E-ring and pull out the shaft. Then remove 8 exit fingers and 1 actuator.

Fig. 16-738
Connector	Spring
Plate spring	Exit sensor

Fig. 16-739

E-ring

Actuator

Fig. 16-740

16

November 2003 © TOSHIBA TEC 16 - 25 e-STUDIO3511/4511 FUSER UNIT/PAPER EXIT SECTION