Toshiba 3511, 4511 manual 1st transfer roller

(9)Stand the transfer belt unit with its front side on the bottom.

(10)Remove 3 screws.

(11)Incline the transfer belt unit so that the shaft is pulled in the unit. Then remove the stay while the shaft is hidden in the unit.

Shaft

Stay

Fig. 14-715

14

(12)Narrow the distance of rollers and pull out the transfer belt unit.

Notes: 1. When installing the transfer belt, make sure it is set at the center not to be moved aside.

2.Make sure that the reflection tape inside of the belt is on the rear side.

3.Do not touch the transfer belt surface with bare hands.

4.Be careful not to scratch the transfer belt.

5.Check the color deviation after replacing the transfer belt.

6.When replacing the transfer belt, remove the oil from drive roller-1, drive roller-2, tension roller, with a solvent such as alcohol first, and attach the transfer belt.

1

12

Transfer belt

Fig. 14-716

[C] 1st transfer roller

(1)Take off the transfer belt ( Chapter 14.7 [B]).

(2)Remove 1 screw and the plate spring.

(3)Remove 1 screw and take off the bracket. Then take off the 1st transfer roller and idling roller.

1st transfer roller	Idling roller
	Plate spring
Bracket	1
	2
	Fig. 14-717

e-STUDIO3511/4511 TRANSFER/TRANSPORT UNIT 14 - 10 November 2003 © TOSHIBA TEC

04/10