Toshiba 4511, 3511 manual Revolver unit

Notes: 1. When installing, insert the shaft of the holder into the revolver unit securely.

2.Apply the grease to the shaft after the replacement of the gears.

Grease

Grease

Fig. 13-714

[H] Revolver unit

(1)Take off all of the color developer units ( Chapter 13.7 [B]).

(2)Take off the cleaner unit ( Chapter 11.7 [A]). Note: When taking off the cleaner, make sure that all the color developer units are taken off in advance. Otherwise the drum surface may be scratched depending on the position of the revolver unit (e.g. developing position).

(3)Take off the receiving tray ( Chapter 2.5.1 [B]).

(4)Take off the left rear cover ( Chapter 2.5.1 [G]).

(5)Take off the color toner cartridge sensor ( Chapter 13.7 [D]).

(6)Take off the color auto-toner sensor ( Chapter 13.7 [E]).

(7)Take off the internal cooling fan ( Chapter

13.7[I]).

(8)Take off the laser optical unit ( Chapter 8.6 [A]).

(9)Release 2 latches take off the laser cooling duct cover (rear side).

(10)Take off the revolver home position sensor ( Chapter 13.7 [F]).

(11)Remove 2 screws and take off the inner cover.

Inner cover

Fig. 13-715

13

November 2003 © TOSHIBA TEC 13 - 11 e-STUDIO3511/4511 REVOLVER UNIT