Toshiba 3511, 4511 manual Remove 2 screws and take off the thermostat from the bracket, Thermistor

(5)Remove 2 screws and take off the thermostat from the bracket.

Thermostat

Bracket

Fig. 16-733

Notes: When installing, pay attention to the followings:

1.Make sure to fix the thermostat, and then harness terminal in order on the bracket.

2.Make sure to keep the gap between the fuser roller and thermostat is 0.7 mm to 2.0 mm while the fuser roller is pressed to the pressure roller.

0.7-2.0mm

[J] Thermistor

(1)Take off the fuser unit ( Chapter 16.7 [A]).

(2)Release the harnesses from the harness clamps.

16

(3)Remove 1 screw of each thermistor and take off total 3 thermistors.

Fig. 16-734

Fig. 16-735

Fig. 16-736

e-STUDIO3511/4511 FUSER UNIT/PAPER EXIT SECTION 16 - 24 November 2003 © TOSHIBA TEC