Toshiba 3511, 4511 manual Color toner cartridge sensor, Rear Front

13

(4)Loosen 2 screws on each holder and take off 2 holders.

(5)Pull out and take off the color developer unit. If the other color developer units still need to be replaced, repeat the procedure (3) to (5). When rotate the revolver unit manually, push down the revolver lock lever and rotate it a little in the direction of white arrow, and then follow the procedure “a”.

Note: When installing the color developer unit, pay attention to the direction of the holder.

[C] Revolver motor

(1)Take off the rear cover ( Chapter 2.5.1 [P]).

(2)Take off the LGC board with the whole case ( Chapter 2.5.2 [A]).

(3)Disconnect 1 connector and remove 4 screws and take off the revolver motor with the whole bracket.

[D] Color toner cartridge sensor

(1)Take off the receiving tray ( Chapter 2.5.1 [B]).

(2)Disconnect 1 connector and remove 1 screw and take off the color toner cartridge sensor with the whole bracket.

[REAR]	[FRONT]	[REAR]	[FRONT]
	Fig. 13-703

	Connector
Fig. 13-704
Connector	Color toner cartridge
	sensor
Fig. 13-705

e-STUDIO3511/4511 REVOLVER UNIT 13 - 8 November 2003 © TOSHIBA TEC