Toshiba 3511, 4511 manual Transfer belt cleaning unit

[F] Transfer belt cleaning unit

(1) Take off the drum cleaner unit ( Chapter 11.6 [A]).

Note: When installing the transfer belt cleaning unit, make sure to take off the drum cleaner unit in advance since it may scratch the drum.

(2)Take off the transfer belt unit ( Chapter 14.7 [A]).

(3)Disconnect 2 connectors and take off the transfer belt cleaning unit.

Note: Do not incline the transfer belt cleaning unit steeply since the toner may fall off.

Transfer belt cleaning unit

Fig. 14-722

14

[G] Transfer belt cleaning blade / Blade seal

(1)Take off the transfer belt cleaning unit ( Chapter 14.7 [F]).

(2)Remove 2 blade seals on both ends of the

transfer belt cleaning blade.

Notes: 1. When putting the blade seal, push the seal firmly in the directions of the arrows in the figure at right. Make sure that there is no gap between the blade and seal.

2.Do not mix up the blade seal for front side and one for rear side since they differ each other.

(3)Release 2 latches and take off the cover.

Blade seal

Fig. 14-723

Cover

Fig. 14-724

e-STUDIO3511/4511 TRANSFER/TRANSPORT UNIT 14 - 12 November 2003 © TOSHIBA TEC

04/10