Toshiba 4511, 3511 manual Bypass transport roller, Bypass pickup roller

(7)Disconnect 1 connector and remove 1 screw. Take off the bypass tray slide guide width detection PC board.

Note: When installing the bracket, make sure that the pointer of the bracket is positioned as shown in the right figure (the same point as it pointed before disassembling).

(A-3) Bypass transport roller

(1)Remove 1 E-ring. Slide the shaft and take off the bypass transport roller.

(A-4) Bypass pickup roller

(1)Remove 1 screw and take off the bypass feed cover by sliding it.

Bypass tray slide guide

width detection PC board

Connector

Fig. 10-409

Pointer

Fig. 10-410

Bypass transport	E-ring
roller
Fig. 10-411

Bypass feed cover

Fig. 10-412

10

November 2003 © TOSHIBA TEC 10 - 13 e-STUDIO3511/4511 PAPER FEEDING SYSTEM