Toshiba 4511, 3511 manual Bearing Fuser belt guide

(1)Remove the cleaning unit ( Chapter 16.7 [B]).

(2)Remove the IH coil ( Chapter 16.7 [D]).

(3)Push down the pressure releasing levers on both sides.

(4)Remove 1 C-ring and 2 gears.

Pressure releasing		Gear
lever	C-ring
	Fig. 16-713

(5) Remove 1 bearing.

(6)Insert a flat-head screwdriver into the slit of the fuser belt guide on the rear side. Then slide the plate while opening the slit by the flat-head screwdriver. Take off the fuser belt guide from

the fuser roller.

Note: Be careful not to scratch the fuser belt.

(7) Remove 2 screws and take off the bracket.

Bearing
Fig. 16-714
Fuser belt guide	Fuser belt
Fig. 16-715

Bracket

Fig. 16-716

16

November 2003 © TOSHIBA TEC 16 - 19 e-STUDIO3511/4511 FUSER UNIT/PAPER EXIT SECTION