Toshiba 4511, 3511 manual Separation finger

(5) Remove 1 E-ring. Then remove 1 bearing.

(6)Lift up the separation roller by sliding it.

(7)Take off the fuser belt.

Note: When installing the fuser belt, place a sheet of paper between the separation plate and fuser belt in order to prevent the fuser belt from being scratched by the separation plate. Keep the paper between then until the fuser roller is installed.

[G] Separation finger

(1)Take off the fuser roller ( Chapter 16.7 [E]).

(2)Lift up the fuser belt unit and take it off. Note: Be careful not to scratch the fuser belt. Lay

the fuser belt on the clean place to prevent the belt from the dust.

E-ring

Bearing

Fig. 16-721

Fuser belt

Separation plate

Separation roller

Fig. 16-722

Fuser belt

Paper

Separation

plate

Fig. 16-723

Fuser belt unit

Fuser belt

Fig. 16-724

16

November 2003 © TOSHIBA TEC 16 - 21 e-STUDIO3511/4511 FUSER UNIT/PAPER EXIT SECTION