Toshiba 3511, 4511 manual Gear assembly

(4)Remove the following parts installed on the shaft of the developer sleeve in order: C-ring, bearing-1, C-ring, E-ring, bearing-2 and oil seal.

*Procedure for replacing an oil seal: Page 12-23

Fig. 12-825

(5)Rear side: Remove 1 screw and take off the gear assembly.

Gear assembly

12

(6)Remove the following parts installed on the shaft of the developer sleeve in order: E-ring, bearing, gear, bearing and oil seal.

(7)Take off the developer sleeve.

*Procedure for replacing an oil seal: Page 12-23

Fig. 12-826

Developer sleeve

Fig. 12-827

(B-4) Mixer

(1)Discharge the developer material ( Chapter 12.8 (B-1)).

(2)Take off the developer sleeve ( Chapter 12.8 (B-3)).

(3)Front side: Remove the following parts in order: E-ring, bushing-1 and bushing-2.

* Procedure for replacing an oil seal:

Page 12-23

Bushing-2

E-ring

E-ring

Bushing-1

Fig. 12-828

e-STUDIO3511/4511 DEVELOPER UNIT 12 - 22 November 2003 © TOSHIBA TEC