Toshiba 3511, 4511 manual IH coil, Fuser roller / Fuser belt guide

(4)Remove 1 E-ring, the gear (C) and 1 bushing from the cleaning roller rear side.

Bushing

E-ring

Gear (C)

Fig. 16-709

16

[D] IH coil

(1)Take off the fuser unit ( Chapter 16.7 [A]).

(2)Release the harnesses from 5 harness clamps. Then remove 1 E-ring, 1 bushing and 2 screws.

(3)Pull out the bracket and IH coil.

(4)Take out the IH coil from the bracket.

Notes: 1. When installing, be sure to set the harnesses “C” and “S” of 4 harnesses on upper.

2.Make sure that there is not any scratch or break on the white tube on the IH coil.

3.Make sure that there is not any peeling or scratch on the harness tube.

[E]Fuser roller / Fuser belt guide

Note: When installing/disinstalling the fuser roller, make sure not to remove the spring (shown in the figure at right) since the removal of this spring may have the fuser roller press to deform the thermistor.

E-ring

Bushing
Fig. 16-710
IH coil
C
S	White tube
	Bracket
Fig. 16-711

Spring

- Rear side -

Spring

- Front side -

Fig. 16-712

e-STUDIO3511/4511 FUSER UNIT/PAPER EXIT SECTION 16 - 18 November 2003 © TOSHIBA TEC