Toshiba 4511, 3511 manual Check Paper, Large Capacity Feeder Cannot Punch, This Size Paper

No.	Message	State of equipment	Note
40	Select a paper size	Displayed when paper size needs to be
	for bypass feeding	specified for bypass feeding such as duplex
		copying
41	Place the blank	Displayed when no paper is in the selected
	sheets in bypass tray	feeder at Cover Copying Mode
	and select the paper
	size
42	Place the blank	Displayed when the direction of cover page
				5
	sheets in the same	is different from that of other pages at Cover
	direction as the	Copying Mode
	originals
43	Place the same size	Displayed when the paper size of cover page
	blank sheets as the	is different from that of other pages at Cover
	originals	Copying Mode
44	Place insertion	Displayed when no insertion sheet is in the
	sheets in the bypass	selected drawer at Sheet Insertion Mode
	tray and select the
	paper size
45	Select the same size	Displayed when the size of insertion sheet
	insert1 sheets as the	(sheet 1) is different from that of other pages
	originals	at Sheet Insertion Mode
46	Select the same size	Displayed when the size of insertion sheet
	insert2 sheets as the	(sheet 2) is different from that of other pages
	originals	at Sheet Insertion Mode
47	Set insert1 sheets in	Displayed when the direction of insertion
	the same direction as	sheet (sheet 1) is different from that of other
	the originals	pages at Sheet Insertion Mode
48	Set insert2 sheets in	Displayed when the direction of insertion
	the same direction as	sheet (sheet 2) is different from that of other
	the originals	pages at Sheet Insertion Mode
49	Set transparency film	Displayed when the selected paper size is
	in A4/LT direction	other than A4/LT at OHP mode
50	CHECK PAPER IN	Papers in LCF are set incorrectly
	LARGE CAPACITY
	FEEDER
51	CANNOT PUNCH	Displayed when the selected paper size is
	THIS SIZE PAPER	not specified for hole punching
52	Remove paper from	Displayed when the paper sizes are mixed at
	the finisher	Staple Sorting Mode
53	Cannot staple this	Displayed when the paper size is not
	size	specified for stapling at Staple Sorting Mode
54	Remove paper from	Finisher is full of papers
	the saddle stitch unit
55	Examine stapler	Trouble in the stapler unit in finisher
56	Check staple	No stapler in finisher section
	cartridge
57	Check staple cartridge	No stapler in saddle stitch unit
	in the saddle stitch unit

November 2003 © TOSHIBA TEC 5 - 5 e-STUDIO3511/4511 CONTROL PANEL