Xerox 5252 manual Drilled Paper

Paper and Paper Trays

Drilled Paper

3-hole drilled paper runs from Trays 1, 2, and 3.

Drilled paper should be run in the Simplex (1-sided) and Duplex (2-sided) orientations shown below to avoid paper jams caused by the holes not aligning correctly with the paper sensor in the press.

Simplex Print Jobs

Load the drilled paper into Trays 1, 2, or 3 Long Edge Feed (LEF) with the holes at the lead edge position. Refer to the following illustration:

	Trays 1 and 2		Tray 3
Rear of paper tray		Rear of paper tray
Left	Paper	Paper	Right
	tray	tray	side
side	guides	guides
Front of paper tray		Front of paper tray

Duplex Print Jobs

Load drilled paper into Trays 1, 2, or 3 with the holes positioned toward the rear of the paper tray. Refer to the following illustration:

Trays 1, 2, and 3

Rear of paper tray

Paper tray guides

Front of paper tray

Note: If you are stapling 3-hole drilled paper with the optional High Capacity Stacker Stapler, refer to the Accessories chapter (see page 6-4)for paper loading instructions, based on the position of the staple.

4-10 DocuColor 5252 Operator Manual