Scanner

Edge/Center Erase

Edge/Center Erase allows you to erase the Left/Right edge, Top/ Bottom edge, and Center from 0 to 50 mm in increments of 1 mm. Left/Right and Top/Bottom can be set independently.

Edge Erase is proportional to Reduce/Enlarge. For example, if Edge Erase is set for 30 mm and 50% reduction is programmed then the amount of Edge Erase will be 15 mm on the output.

When using 2-Sided Output, the same amount of erasure applies to sides 1 and 2.

Center Erase erases the shadow line from scanning the spine of a bound original (for example a book or a magazine). It is also useful for erasing the boundary line between two documents placed side by side on the Document Glass.

Center Erase may be specified between 0-50 mm in increments of 2 mm. When you specify a value, each side of the center is erased by half of the specified value. A Center Erase value of 30 mm results in 15 mm being erased from either side of the center.

For some original image sizes, Edge/Center Erase does not occur exactly in the center of the output image. Center Erase default is 0 mm., which can be changed in Tools Mode. Refer to the System Administration Guide (see page 2-75)for more information on how to change this setting.

5 Scanner

DocuColor 5252 Operator Manual

5-59

Page 167
Image 167
Xerox 5252 manual Edge/Center Erase