Xerox 5252 manual Transparency Guidelines

Paper and Paper Trays

Transparency Guidelines

Transparencies can be run ONLY from Tray 3.

•Load transparencies into Tray 3 with the paper stripe side facing DOWN and with the stripe as the leading edge. (The leading edge is the edge that feeds into the digital press first.)

•Do not mix paper and transparencies in Tray 3. Jams may occur.

•Ensure that Transparency is selected in the weight section on the paper tray.

Use only the transparencies recommended:

•Xerox Removable Paper Stripe: USA and Canada, 3R5765; Xerox Europe, 3R93179.

Tabbed Inserts

Tabbed Inserts can be loaded into Tray 3 as nonstandard paper.

•When loading, the nontabbed, short edge of the tabbed insert should be the lead edge to the digital press.

•If a jam occurs while running tabbed sets, there is no recovery procedure.

•You have to manually reassemble your originals and prints, determine where the job left off, and resume printing or cancel the job and start again.

•The size of the tabbed insert should be 9 x 11 inch (229 x 279 mm) for letter size tabs (223.5 x 296 mm for A4 equivalent tabs).

•The proper weight of the insert should be selected on the tray.

•Select Non-standard size and input 11 inches or 296 mm for A4 as the X axis and 9 inches or 223.5 mm for A4 as the Y axis dimensions for SEF.

Refer to the System Administration Guide (see page 2-42)for the procedure to program nonstandard size paper.

4 Paper and Paper Trays

DocuColor 5252 Operator Manual 4-9