Page 6

Epson Research and Development

 

Vancouver Design Center

 

 

Scripting

13705PLAY can be driven by a script file. This is useful when:

there is no standard display output to monitor command entry and results.

various registers must be quickly changed faster than can achieved by typing.

The same series of keystrokes is being entered time and again.

A script file is an ASCII text file with one 13705PLAY command per line. All scripts must end with a “q” (quit) command in order to return control to the operating system. The semi- colon is used as a comment delimitor. Everything on a line after the semi-colon will be ignored.

On a PC platform, a typical script command line is: “13705PLAY < dumpregs.scr > results”.

This causes the script file “dumpregs.scr” to be interpreted and the results to be sent to the file “results.”

Example 1: The script file “dumpregs.scr” can be created with and text editor and will look like the following:

; This file initializes the S1D13705 and reads the registers

i

; Initialize the registers.

xa

; Dump all the registers

la

; And the LUT

q

; Exit

Comments

All numeric values are considered to be hexadecimal unless identified otherwise. For example, 10 = 10h = 16 decimal; 10t = 10 decimal; 010b = 2 decimal.

Redirecting commands from a script file (PC platform) allows those commands to be executed as though they were typed.

S1D13705

13705PLAY Diagnostic Utility

X27A-B-005-04

Issue Date: 01/07/04

Page 226
Image 226
Epson S1D13705 technical manual Scripting, Comments