Epson S1D13705 technical manual Decode Addresses, Values for the Register address and Display

Page 8	Epson Research and Development
	Vancouver Design Center

Decode Addresses	Selecting one of the listed evaluation platforms changes
	the values for the “Register address” and “Display
	buffer address” fields. The values used for each evalu-
	ation platform are examples of possible implementa-
	tions as used by the Epson S1D13705 evaluation board.
	If your hardware implementation differs from the
	addresses used, select the User-Defined option and
	enter the correct addresses for “Register address” and
	“Display buffer address”.
Register Address	The physical address of the start of register decode
	space (in hexadecimal).
	This field is automatically set according to the Decode
	Address unless the “User-Defined” decode address is
	selected.
Display Buffer Address	The physical address of the start of display buffer
	decode space (in hexadecimal).
	This field is automatically set according to the Decode
	Address unless the “User-Defined” decode address is
	selected.

Note

When “Epson S5U13705B00C Rev. 2 Evaluation Board” is selected, the register and display buffer addresses are blanked because the evaluation board uses the PCI interface and the decode addresses are determined by the system BIOS during boot-up.

If using the S1D13705 Evaluation Board on a PCI based platform, both Windows and the S1D13XXX device driver must be installed. For further information on the S1D13XXX device driver, see the S1D13XXX Windows 32-bit Windows Device Driver Installation Guide, document number X00A-E-003-xx.

S1D13705	13705CFG Configuration Program
X27A-B-001-03	Issue Date: 02/03/11