Page 14 Epson Research and Development
Vancouver Design Center
S1D13705 S5U13705B00C Rev. 1.0 ISA Bus Evaluation Board User Manual
X27A-G-005-03 Issue Date: 01/02/13
6 Technical Description

6.1 Embedded Memory Support

The S1D13705 contains 80K bytes of embedded, 16-bit, SRAM used for the disp lay buffer
and a 32 byte internal register set.
Since the S1D13705 does not distinguish between memory and register acc es ses, both the
80K byte display buffer and the 32 byte register set must be memory mapped into the host’s
memory space.
When using the S5U13705B00C board on an ISA bus system, the board can be configured
to map the S1D13705 to one of two memory blocks.
The SRAM start address is determined by a DIP switch setting. See Table 2-1: “Configu-
ration DIP Switch Settings,” on page 8.
1. When switch S1-5 is in the closed position, the S1D13705 is mapped into segments
0C0000h and 0D0000h.
This memory space is in the first 1M byte of ISA bus memory and should be used if
these segments are not taken up by other devices such as network adapters, SCSI
cards, or other peripherals.
Note
Since VGA and VGA compatible video adapters use address 0C8000, these cards can-
not be used while using the S5U13705B00C board at this memory address. A mono-
chrome display adapter, a terminal, or a non-VGA compatible display adapter must be
used.
2. When switch S1-5 is in the open position, the S1D13705 is mapped into the upper
megabyte of ISA bus memory, starting address of F00000h. To use this memory on an
ISA bus system, the system BIOS has to be co nfigured to set a memory ‘hole’ starting
at this address. Some systems allow the u ser to configure the size of this hole and th e
starting address of where it begins while others just allow a 1M byte hole at the top of
the 16M byte memory space. This memory hole is configured by entering the system
CMOS Setup Utility. This memory space should be used if segments 0Dh and 0Eh are
being used by other devices or if a VGA display adapter is needed.
Starting at the SRAM start address, the board design decodes a 12 8K byte segment acc om-
modating both the 80K byte display buffer and the S1D13705 internal register set. The
S1D13705 registers are mapped into the upper 32 bytes of the 128K byte segment (1FFE 0h
to 1FFFFh).
When using the S5U13705B00C board on a non-ISA bus system, system or external
decode logic must map the S1D13705 into an appropriate memory space.