Configuring PPTP | PPTP and L2TP VPN |
|
|
Configuring the FortiGate unit as a PPTP gateway
Use the following procedures to configure the FortiGate unit as a PPTP gateway:
To add users and user groups
Add a user for each PPTP client.
1Go to User > Local.
2Add and configure PPTP users.
For information about adding and configuring users, see “Adding user names and configuring authentication” on page 224.
3Go to User > User Group.
4Add and configure PPTP user groups.
For information about adding and configuring user groups, see “Configuring user groups” on page 229.
To enable PPTP and specify an address range
1Go to VPN > PPTP > PPTP Range.
2Select Enable PPTP.
3Enter the Starting IP and the Ending IP for the PPTP address range.
4Select the User Group that you added in “To add users and user groups” on page 258.
5Select Apply to enable PPTP through the FortiGate unit.
Figure 64: Example PPTP Range configuration
To add a source address
Add a source address for every address in the PPTP address range.
1Go to Firewall > Address.
2Select the interface to which PPTP clients connect. This can be an interface, VLAN subinterface, or zone.
258 | Fortinet Inc. |
