Configuration example: Multiple connections to the Internet | NAT/Route mode installation |
|
|
Registering your FortiGate unit
After purchasing and installing a new FortiGate unit, you can register the unit by going to the System Update Support page, or using a web browser to connect to http://support.fortinet.com and selecting Product Registration.
To register, enter your contact information and the serial numbers of the FortiGate units that you or your organization have purchased. You can register multiple FortiGate units in a single session without
For more information about registration, see “Registering FortiGate units” on page 128.
Configuring virus and attack definition updates
You can go to the System Update page to configure the FortiGate unit to automatically check whether new versions of the virus definitions and attack definitions are available. If it finds new versions, the FortiGate unit automatically downloads and installs the updated definitions.
The FortiGate unit uses HTTPS on port 8890 to check for updates. The FortiGate external interface must have a path to the FortiResponse Distribution Network (FDN) using port 8890.
For information about configuring automatic virus and attack updates, see “Updating antivirus and attack definitions” on page 117.
Configuration example: Multiple connections to the Internet
This section describes some basic routing and firewall policy configuration examples for a FortiGate unit with multiple connections to the Internet (see Figure 9). In this topology, the organization operating the FortiGate unit uses two Internet service providers to connect to the Internet. The FortiGate unit is connected to the Internet using the external and DMZ interfaces. The external interface connects to gateway 1, operated by ISP1 and the DMZ interface connects to gateway 2, operated by ISP2.
You can add ping servers to interfaces and configure routing to control how traffic uses each Internet connection. With this routing configuration, you can create firewall policies to support multiple Internet connections.
This section provides some examples of routing and firewall configurations for the FortiGate unit for multiple Internet connections. To use the information in this section, you should be familiar with FortiGate routing (see “Configuring routing” on page 153) and FortiGate firewall configuration (see “Firewall configuration” on page 185).
The examples below show how to configure
•Configuring ping servers
•
•Policy routing examples
•Firewall policy example
50 | Fortinet Inc. |