UM10237_2 © NXP B.V. 2008. All rights reserved.
User manual Rev. 02 — 19 December 2008 277 o f 792
NXP Semiconductors UM10237
Chapter 11: LPC24XX Ethernet
The flexibility of the descriptors used in the Ethernet block allows the possibility of defining
memory buffers in a range of sizes. In order to analyze bus bandwidth requirements,
some assumptions must be made about these buffers. The "worst case" is not addressed
since that would involve all descriptors pointing to single byte buffers, with most of the
memory occupied in holding descriptors and very little data. It can easily be shown that
the AHB cannot handle the huge amount of bus traffic that would be caused by such a
degenerate (and illogical) case.
For this analysis, an Ethernet packet is assumed to consist of a 64 byte frame.
Continuous traffic is assumed on both the transmit and receive channels.
This analysis does not reflect the flow of Ethernet traffic over time, which would include
inter-packet gaps in both the transmit and receive channels that reduce the bandwidth
requirements over a larger time frame.
Types of DMA access and their bandwidth requirements
The interface to an external Ethernet PHY is via either MII or RMII. An MII operates at
25 MHz, transferring a byte in 2 clock cycles. An RMII operates at 50 MHz , transferring a
byte in 4 clock cycles. The data transfer rate is the same in both cases: 12.5 Mbps.
The Ethernet block initiates DMA accesses for the following cases:
•Tx descriptor read:
–Transmit descriptors occupy 2 words (8 bytes) of memory and are read once for
each use of a descriptor.
–Two word read happens once every 64bytes (16 words) of transmitted data.
–This gives 1/8th of the data rate, which = 1.5625Mbps.
•Rx descriptor read:
–Receive descriptors occupy 2 words (8 bytes) of memory and are read once for
each use of a descriptor.
–Two word read happens once every 64bytes (16 words) of received data.
–This gives 1/8th of the data rate, which = 1.5625Mbps.
•Tx status write:
–Transmit status occupies 1 word (4 bytes) of memory and is written once for each
use of a descriptor.
–One word write happens once every 64 bytes (16 words) of transmitted data.
–This gives 1/16th of the data rate, which = 0.7813 Mbps.
•Rx status write:
–Receive status occupies 2 words (8 bytes) of memory and is written once for each
use of a descriptor.
–Two word write happens once every 64bytes (16 words) of received data.
–This gives 1/8 of the data rate, which = 1.5625 Mbps.
•Tx data read:
–Data transmitted in an Ethernet frame, the size is variable.
–Basic Ethernet rate = 12.5 Mbps.
•Rx data write: