UM10237_2 © NXP B.V. 2008. All rights reserved.
User manual Rev. 02 — 19 December 2008 644 o f 792
NXP Semiconductors UM10237
Chapter 25: LPC24XX Pulse Width Modulator PWM0/PWM1
[1] Reserved for PWM0.
6.6 PWM Control Registers (PWM0PCR - 0xE001 404C and PWM1PCR 0xE001 804C)

The PWM Control registers are used to enable and select the type of each PWM channel.

The function of each of the bits are shown in Table 25–563.

3 Capture on
PCAPn.1
rising edge[1]
0 This feature is disabled. 0
1 A synchronously sampled rising edge on the PCAPn.1 input
will cause CR1 to be loaded with the contents of the TC.
4 Capture on
PCAPn.1
falling edge[1]
0 This feature is disabled. 0
1 A synchronously sampled falling edge on PCAPn.1 will cause
CR1 to be loaded with the contents of TC.
5 Interrupt on
PCAPn.1
event[1]
0 This feature is disabled. 0
1 A CR1 load due to a PCAPn.1 event will generate an
interrupt.
31:6 - Reserved, user software should not write ones to reserved
bits. The value read from a reserved bit is not defined. NA
Table 562: PWM Capture Control Register (PWM0CCR - address 0xE001 4028 and PWM1CCR
address 0xE001 8028) bit description
Bit Symbol Value Description Reset
Value
Table 563: PWM Control Registers (PWMPCR - address 0xE001 404C and PWM1PCR
address 0xE001 804C) bit description
Bit Symbol Value Description Reset
Value
1:0 Unused Unused, always zero. NA
2 PWMSEL2 PWM2 output single/double edge mode control. 0
1 Double edge controlled mode is selected.
0 Single edge controlled mode is selected.
3 PWMSEL3 1 PWM3 output edge control. See PWMSEL2 for details. 0
4 PWMSEL4 1 PWM4 output edge control. See PWMSEL2 for details. 0
5 PWMSEL5 1 PWM5 output edge control. See PWMSEL2 for details. 0
6 PWMSEL6 1 PWM6 output edge control. See PWMSEL2 for details. 0
8:7 - Reserved, user software should not write ones to reserved
bits. The value read from a reserved bit is not defined. NA
9 PWMENA1 The PWM1 output enable control. 0
0 The PWM output is disabled.
1 The PWM output is enabled.
10 PWMENA2 The PWM2 out put enable control. See PWMENA1 for details. 0
11 PWMENA3 The PWM3 outpu t enable control. See PWMENA1 for details. 0
12 PWMENA4 The PWM4 outpu t enable control. See PWMENA1 for details. 0
13 PWMENA5 The PWM5 outpu t enable control. See PWMENA1 for details. 0
14 PWMENA6 The PWM6 outpu t enable control. See PWMENA1 for details. 0
31:15 Unused Unused, always zero. NA