NXP Semiconductors UM10237 5.3 Slave operation, 5.4 Exception conditions

UM10237_2 © NXP B.V. 2008. All rights reserved.
User manual Rev. 02 — 19 December 2008 529 o f 792
NXP Semiconductors UM10237
Chapter 19: LPC24XX SPI
5. Read the SPI status register.
6. Read the received data from the SPI data register (optional).
7. Go to step 3 if more data is required to transmit.
Note: A read or write of the SPI data register is required in order to clear the SPIF status
bit. Therefore, if the optional read of the SPI data register does not take place, a write to
this register is required in order to clear the SPIF status bit.
5.3 Slave operation
The following sequence describes how one should process a data transfer with the SPI
block when it is set up to be a slave. This process assumes that any prior data transfer
has already completed. It is required that the system clock driving the SPI logic be at le ast
8X faster than the SPI.
1. Set the SPI control register to the desired settings.
2. Write the data to transmitted to the SPI data register (optional). Note that this can only
be done when a slave SPI transfer is not in progress.
3. Wait for the SPIF bit in the SPI status register to be set to 1. The SPIF bit will be set
after the last sampling clock edge of the SPI data transfer.
4. Read the SPI status register.
5. Read the received data from the SPI data register (optional).
6. Go to step 2 if more data is required to transmit.
Note: A read or write of the SPI data register is required in order to clear the SPIF status
bit. Therefore, at least one of the optional reads or writes of the SPI data register must
take place, in order to clear the SPIF status bit.
5.4 Exception conditions
Read Overrun
A read overrun occurs when the SPI block internal read buffer contains data that has not
been read by the processor, and a new transfer has completed. The read buffer
containing valid data is indicated by the SPIF bit in the status register being active. When
a transfer completes, the SPI block needs to move the received data to the read buffer. If
the SPIF bit is active (the read buffer is full), the new receive data will be lost, and the read
overrun (ROVR) bit in the status register will be activated.
Write Collision
As stated previously, there is no write buffer between the SPI block bus interface, and the
internal shift register. As a result, data must not be written to the SPI data register when a
SPI data transfer is currently in progress. The time frame where data cannot be written to
the SPI data register is from when the transfer starts, until after the status register has
been read when the SPIF status is active. If the SPI data register is written in this time
frame, the write data will be lost, and the write collision (WCOL) bit in the status register
will be activated.
Mode Fault