Panasonic SX-KN7000 operating instructions 202

	Phenomenon	Remedy
	Storage is not possible.	• The remaining memory capacity of the COMPOSER
		is 0.
	Setting the time signature is not possible.	• The time signature cannot be changed for a pattern
COMPOSER		which is currently recorded in the COMPOSER. If you
		wish to change the time signature, first follow the
		procedure to clear the memory. (Refer to page 110.)
	The playback timing of the rhythm pattern is	• The QUANTIZE function was on when the pattern was
	different from the timing with which it was recorded.	recorded and the timing was automatically corrected.
		Set the quantize level to a smaller note unit or to OFF
		when recording. (Refer to page 112.)
	The Disk Drive produces a noise during recording	• This occurs when the Disk Drive is reading a disk. It
card	or playback.	does not indicate a problem.
	When the procedure to load from a disk/SD card	• When performing the load operation from a disk\SD
Disk/SD
	is performed, the contents of the keyboard memory	card, the keyboard memory changes to that of the
	are erased.	data loaded from the disk. If you wish to preserve a
		song which is stored in the keyboard memory, save it
		on a disk/SD card before performing the load
		procedure.
	Data cannot be exchanged through MIDI terminals.	• Match the channels on the transmitting side and the
		receiving side. (Refer to page 190.)
	The sound quavers or is distorted.	• When the USB terminal or both the MIDI IN and OUT
		terminals are connected to a computer, depending on
		the computer software the received data may be sent
MIDI		back to the instrument just as it is. Because of this
		the sound generated from the keys and the sound
		generated from the returned data are both produced,
		causing undesirable effects, such as the sounds
		canceling each other out, for example. In this case,
		either change the software settings to prevent
		received data from being returned, or set the MIDI
		LOCAL CONTROL to off.
	Noise from a radio or TV can be heard.	• This sometimes occurs when electrical equipment
		such as a radio or TV is used near the instrument. Try
		moving such electrical equipment further away from
		the instrument.
Other		• The sound may be coming from a nearby broadcast
		station or amateur radio station. If the sound is
		bothersome, consult your dealer or service center.
	The cabinet becomes warm during use.	• This instrument has a built-in power source that heats
		the cabinet to some degree. This is not an indication
		of trouble.

202

QQTG0671