Part IV

Sequencer

Store a rhythm progression

Changes in the rhythm selection and tempo, as well as the intro, fill-ins and the ending, can be stored by measures with the step recording method.

Sequencer

1.On the SEQ MENU display, use the SONG SELECT and buttons to select the song number. Then select RECORD & EDIT.

2.On the RECORD & EDIT display, select STEP RECORD.

The display changes to the PART SELECT display.

3.Using the balance buttons below the display, select the track to which the RHYTHM (RHY) part has been assigned.

The display changes to the STEP RECORD: RHYTHM input display similar to the following.

4.Use the MEAS and buttons to go to the measure you wish to record.

5.Store the rhythm data.

Data which can be stored:

START/STOP

Changes in the rhythm selection

COUNT INTRO, INTRO, FILL IN,

ENDING Tempo changes

Be sure to store the START/STOP data in the measure in which the rhythm starts or stops.

If you are storing a COUNT INTRO or INTRO, store this data before the START/STOP data.

If the tempo is changed, the display changes to the confirmation display. After specifying the desired tempo, Press the YES button to store the specified tempo, or press the NO button to cancel the new tempo value.

6.Repeat steps 4 and 5 to continue storing the rhythm progression.

7.At the end of the rhythm progression, press the END button.

If the REP button is pressed instead of the END button, during playback the recorded rhythm progression is repeated.

The Keyboard exits the recording mode.

Correct the recorded rhythm progression

1.Follow the procedure to select the STEP RE- CORD: RHYTHM display.

2.Use the MEAS buttons to go to the measure you wish to modify. (The * is highlighted.)

3.Correct the rhythm data.

Press the ERS button to erase data at the cursor position.

If you wish to cancel the REPEAT, enter an END command.

If you select a rhythm with a different time signature, the time signature of all subsequent measures will also change.

If data has already been recorded in other tracks, you cannot select a rhythm with a different time signature.

TRACK CLEAR

To erase all data from the current track, press the CLR button, and then press the YES button on the confirmation display.

If you wish to cancel the clear procedure, press the NO button.

94

QQTG0671

Page 94
Image 94
Panasonic SX-KN7000 Store a rhythm progression, Start/Stop, Count INTRO, INTRO, Fill, Ending Tempo changes