Part V

Composer

Composer

Part Setting

You can make detailed settings for each part.

1.On the REALTIME RECORDING display, press the PART SETTING button.

The settings comprise two pages of the dis- play. Use the PAGE buttons to switch pages.

2.Use the PART and buttons to select a part.

3.Use the and buttons to set the correspond- ing item.

<PAGE 1>

PITCH POINT:

The pitch at which the pattern progression sound is lowered by one octave.

When the root note of the specified chord is higher than the set pitch point, the pitch of that part is automatically lowered by one octave, thus avoiding an unnaturally high accompani- ment pitch.

This is effective only for the part for which the Melody group was selected in CHORD MOD-

IFY CHANGE.

SOUND:

Use the panel buttons to select the sound.

DIGI EFF:

Set the DIGITAL EFFECT to on or off.

(SOUND) is the initialized setting of the sound.

BALANCE:

Adjust the volume balance.

PAN:

Adjust the stereo balance of each part (LEFT 64 – CENTER – RIGHT 63).

At “LEFT 64”, the sound is all the way to the left, at “RIGHT 63” all the way to the right. The center point is CENTER.

BEND RANGE:

Adjust the range of pitch change when the PITCH BEND wheel is operated (0 to 12).

<PAGE 2>

EQ-Hi:

Sound correction in the high range.

Use the FC and buttons to adjust the standard frequency. Use the GAIN and buttons to set the ratio of change.

EQ-Low:

Sound correction in the low range.

Use the FC and buttons to adjust the standard frequency. Use the GAIN and buttons to set the ratio of change.

DSP1:

TOTAL MODE: Depth of DSP1 (0 to 127).

SOUND MODE: DSP 1 on/off (– – ) setting

DSP2:

DSP2 on/off (– – ) setting.

REV:

Depth of the REVERB (0 to 127).

CHO:

Depth of the CHORUS (0 to 127).

114

QQTG0671

Page 114
Image 114
Panasonic SX-KN7000 operating instructions Part Setting