Part I | Sounds and effects |
RIGHT 1/RIGHT 2 OCTAVE
During your performance you can quickly change the octave of the RIGHT 1 and RIGHT 2 parts. Use this convenient function to expand the oc- tave range of the keyboard, especially during a
Use the R1/R2 OCTAVE buttons (+ and – ) to change the octave.
R1/R2 OCTAVE
_ +
•Press the + button to raise the pitch and the
– button to lower the pitch (– 2 to +2).
•The display looks similar to the following.
•You can also use the ∧ and ∨ buttons on the R 1/R 2 OCTAVE display to change the oc- tave.
•The display returns to the previous display after a few seconds.
•A lit + or – indicator shows that the octave has been changed.
•To cancel the octave change, press both but- tons at the same time.
•The note pitches (NOTE NUMBER) recorded in the SEQUENCER and during MIDI trans- mission are also affected by this octave set- ting. However, it does not affect SEQUENCER playback or received MIDI data.
Sounds and effects
SOLO
Each part can be set to monophonic sound.
1.Select a part.
2.Press the SOLO button to turn it on.
SOLO
•The sound of that part will be monophonic.
•This effect does not work for the sounds in the DRUM KITS sound group.
•When two CONDUCTOR parts, one with the SOLO turned on and one with the SOLO turned off, are mixed, then only the highest pitch of the played chord plays in the sound for which the SOLO is turned on.
•In the initialized condition, the SOLO is auto- matically turned on or off depending on the sound you select.
41
