Part I

Sounds and effects

3.Use the and buttons to select a GROUP of sound.

4.Use the buttons on both side of the display to select the sound.

The numerical value that is displayed for each sound is the MIDI [BANK MSB, LSB]-PRO- GRAM CHANGE number.

GM2 sounds are selected on this display.

ALPHABET

Press the CATEGORY button to show the sound names in alphabetical order.

Press the ALPHABET button to return to the CATEGORY display.

effects

Digital Drawbar

You can play organ sounds while controlling the drawbars on the display.

Sounds and

1.In the PART SELECT section, select a part.

2.Press the DIGITAL DRAWBAR button to turn

it on.

DIGITAL

DRAWBAR

The display looks similar to the following.

3.Use the balance buttons below the display to adjust the volume of each drawbar.

The volume of each drawbar is illustrated on the display and changes when you press the corresponding balance buttons to adjust the volume.

The DIGITAL DRAWBAR can not be selected for the ACCOMP and BASS parts of the COM- POSER or PERFORMANCE PADS.

Change the sound type

Use the <Jazz Drawbars> / <Rock Drawbars> button to select the type of sound.

PERCUSSIVE TONE

PERCUSSIVE TONE adds a tone with a fast ini- tial attack to the drawbar sounds. You can select two pitch levels of attack tones.

Use the PERCUSSIVE TONE 2 2/3’ and 4’ but- tons to turn the respective tone on or off.

The buttons are red when they are on.

TREMOLO

Tremolo is a rapid oscillation in volume, like the effect of a rotating speaker. The tremolo speed can be changed while you are playing.

The SOUND DSP (ROTARY SPEAKER/ ROCK ROTARY) is used for the tremolo effect. This effect does not work if the SOUND DSP button is turned off.

Use the TREMOLO button to switch between the SLOW and FAST rotating speeds.

The tremolo setting is effective for each part in common.

The types of SOUND DSP used with the TREMOLO effect are as follows:

Jazz Drawbars: ROTARY SPEAKER

Rock Drawbars: ROCK ROTARY

TREMOLO does not work for parts which can- not use the SOUND DSP.

Other settings

DRAWBAR ATTACK TIME:

Use the ATTACK and buttons to adjust the time it takes for the drawbar sound to sound after a key is played.

DRAWBAR RELEASE TIME:

Use the RELEASE and buttons to ad- just the time it takes for the drawbar sound to die out after the keys are released.

PERCUSSIVE TONE DECAY:

Use the DECAY and buttons to adjust the time it takes for the percussive tone to die out.

PERCUSSIVE TONE LEVEL:

Use the LEVEL and buttons to adjust the volume of the percussive tone.

The above settings are effective for the RIGHT 1, RIGHT 2 and LEFT parts in common.

36

QQTG0671

Page 36
Image 36
Panasonic SX-KN7000 operating instructions Digital Drawbar, Alphabet, Percussive Tone, Tremolo