Part IV | Sequencer |
CYCLE PLAY
You can aurally check the data you are editing by accessing the CYCLE PLAY display from the NOTE EDIT display.
•If you wish other tracks to be played back, they should be selected beforehand on the SEQUENCER PLAY display. (Refer to page 83.)
1.On the NOTE EDIT display, press the PLAY button.
•The display looks similar to the following.
2.Use the START MEASURE ∧ and ∨ buttons to select the beginning playback measure.
3.Use the END MEASURE ∧ and ∨ buttons to select the last playback measure.
4.Press the START/STOP button.
•Cycle playback of the specified measures begins.
•If the SOLO button is turned on, playback changes to that of the recording track only. If it is turned off, all the tracks specified on the SEQUENCER PLAY display are played back.
5.To stop cycle playback, press the START/ STOP button again.
•During playback stop, if the SEQUENCER RESET (FILL IN 1) button is pressed, the SEQUENCER returns to the measure number specified in step 2. If the SEQUENCER RESET button is pressed again, the SEQUENCER returns to measure 1.
Drum Edit
The DRUMS part can be edited on a specialized display. This differs from the normal STEP RECORD edit procedure, and is a convenient way to check the data for each note.
1.On the SEQ MENU display, select RECORD & EDIT.
2.On the RECORD & EDIT display, select DRUM EDIT.
3.On the PART SELECT display, select the track for the DRUMS part.
•The CHORD, RHYTHM and CONTROL tracks cannot be selected.
•The display looks similar to the following.
4.Use the SOUND ▲ and ▼ buttons to select the percussion instrument you wish to edit.
•The number to the left of the instrument name is its MIDI NOTE NUMBER in the Technics arrangement.
•If sounds other than percussion instrument sounds are assigned, they are not displayed.
5.Use the MEAS ▲ and ▼ buttons to select the measure you wish to edit.
6. Use the CURSOR | ▲ | and | ▼ | buttons to |
move the cursor (▼) to the point you wish to edit.
•Recorded performance data is shown as ver- tical bars. Data selected for editing is highlighted.
•You can use the INC ∧ and ∨ buttons to change the increment of cursor movement.
The resolution can be set at /96. However, if NOTE data is present between increments, the cursor will stop.
•Use the POS ∧ and ∨ buttons to change the value.
Sequencer
99
