Savin 2045e appendix Change Initial Mode, Selecting a custom size

vChange Initial Mode

If you use the settings which are displayed when modes are cleared, reset, or immediately after the op- eration switch is turned on as the initial mode, select [Standard].

Select [Program No.10] when you use the settings stored in Program No.10 as the initial mode.

Selecting a custom size

When selecting [Custom size] as the scan size, follow the procedure be- low.

A Press [Custom size] on the Scan Size Setting screen.

B Enter the original size with the number keys.

Select and enter values for [X1] and [Y1], and then press the {#}key.

C Enter the scan starting point in re- lation to the standard scan start- ing point.

Select and enter values for [X2] and [Y2], and then press the {#}key.

Initial Scanner Setup

D Enter the scan size (area) with the number keys.

Select and enter values for [X3] and [Y3], and then press the {#}key.

2

Depending on how the original is positioned, the scan area will be as follows:

Original orientation Original orientation

glass	X2	X3	X3	X2
	Y2
exposure	Y3	X1	Y3	X1
		Y1		Y1
			Y2
on the		X3 X2	X3	X2
placed
	Y2
	Y3		Y2
When		Y1	Y3	Y1
		X1		X1

	X2	X3	X2	X3
ADFthein	Y2	X1	Y2	X1
	Y3		Y3
				Y1
		Y1
When placed

ZHSY055N

shows the face of the original.

shows the back of the original.

shows the feeding direction.

The range of possible original sizes and scan sizes is as follows:

•Original Size

X1: 140 - 432 mm (5.5” - 17.0”)

Y1: 140 - 297 mm (5.5” - 11.7”)

19