Decide the placement method.
Place the Place the Place the top Place the
original so original so edge of the original so
Place the original.that the top that the top original first. that the top
(There are two original orien- edge touches edge touchesedge touches
tations.)the top left of the rear ofthe back of
the expo- the exposurethe ADF. sure glass. glass.
Exposure glass
An original to be scanned

3. Setting Originals

This chapter explains the procedure for placing originals on the exposure glass and in the ADF, and setting the original scan area and orientation according to the placement method.

To correctly display the top/bottom orientation of the scanned original on a cli- ent computer, the placement of the original and the settings made on the control panel and scanner driver must match.

Placing Originals

There are two orientations for placing the original. See the table below.

Note

rNormally, an original is or , but in the table below, a square original is used to make original orientation easy to understand. If the actual shape of the original is different, the combination of original orientation and the orien- tation specified on the control panel or scanner driver does not change.

vSpecifying original orientation and setting originals

Org.eps

ADF

35

Page 45
Image 45
Savin 2045e appendix Placing Originals, Specifying original orientation and setting originals