Topcon A2677 manual

NOTICE NOTICE

A wheel Calibration Factor of no greater than 0.6m (24 inches) is required. See Section

1.Glue the magnets to the wheel studs (Figure 5-6), with the side marked with a plus (+) facing the Shaft/Speed Sensor.

TIP

Use any silicone or epoxy type adhesive to glue the magnets to the wheel studs. Make sure you leave adequate time for the glue to set.

NOTICE NOTICE

Space the magnets equally around the wheel, on all the available wheel studs (Figure 5-6), to ensure accurate speed updates.

Figure 5-6. Shaft/Speed Sensor on an Un-Driven Wheel Installation

5-12	www.topconpa.com