Topcon A2677 manual Type, Input Gain, Flow

X20 Sprayer Reference Manual

Type

•5 Bar—select this if using the standard TPA Pressure Sensor

•10 Bar—select this if a 10 Bar Pressure Sensor is fitted. See “Calibrating the Pressure Sensor”, page 10-3.

Input Gain

•x1—select this (default) if the Spray Interface controller was purchased after July 2005

•x2—select this if the Spray Interface controller was purchased before July 2005.

Please note: When the Spray ECU is selected Input Gain is not required.

Flow

NOTICE NOTICE

Most Flow Sensors have a calibration factor stamped or labeled on the Flow Sensor body. The factor will be in pulses per volume, (volume can be Litres, US Gallons etc).

This factor may be entered manually into the Flow Sensor Specifications window. Make sure the units (volume), selected from the Units page (page 8-38), corresponds to the units used on the Flow Sensor.

If the Flow Meter calibration is not known or the operator wants to check the Calibration Factor, return to the Working screen, see “Calibrating the Flow Meter”, page 10-13.

8-38 www.topconpa.com