
X20 Sprayer Reference Manual
NOTICE NOTICE
The Regulator Valve may require a connector change to attach to the
CAUTION CAUTION
Care should be taken, when replacing these connectors, not to damage the Sprayer Harness or Regulator Valve and connectors should be fully circuit tested prior to installation.
When you test the Sprayer with water you may find that the Regulator Valve works in the opposite direction to what you require. For example: The pressure increases when it should decrease. You can set the Reverse Valve Direction in the Sprayer software setup to remedy this, see “Reverse Valve Direction”, page
Pressure Sensor Installation and Connection
1.Mount the Pressure Sensor (A092) (Figure
The supplied Pressure Sensor is a 5 Bar (72 psi) Pressure Sensor.
NOTICE NOTICE
To properly measure Spray Line operating pressure the Pressure Sensor must be positioned between the Flow Meter and the Section Valves (Figure
A2677 Rev 1.5 |