X20 Sprayer Reference Manual
Setup
Once a Sprayer or Sprayer kit is selected then most of the Sprayer values and settings will be loaded into the Sprayer software Options and you will only have to enter a few values (eg. Section Widths, Unit type, Wheel Calibration Factor) to get started.
You must choose one of two options:
•Go to "Setting Up the Software", Chapter 8 of the Software Setup and work through the manual, which outlines all the Sprayer options within the software
OR
•Use the Quick Setup Guide (below) and enter in the Sprayer settings which are unique to your Sprayer.
Quick Setup Guide
1.Select the Change/View Configuration button
This will allow you to view the settings of the Sprayer that was loaded.
For help with understanding and navigating the Options windows see Appendix A.
2.Select the COM Port the Spray ECU is connected to on the back of the console, on the ECU page, see page
3.Enter the Tank Capacity of the Sprayer, on the Tanks page, see page
4.Change the number of sections if they are different to the ones displayed on the Sections page, see page
www.topconpa.com |
