Toshiba W7 manual Preset Speed #13, Preset Speed #14, Preset Speed #15, Preset Speed Mode Control

Preset Speed #13							Proportional (P) Gain
Preset Speed #13
Program		Preset Speeds			13		Parameter Type — Numerical
This parameter assigns an output frequency to binary number 1101 and is							Factory Default — 0.00
identified as Preset Speed #13. The binary number is applied to S1 – S4 of the							Changeable During Run — Yes
Control Terminal Strip to output the Preset Speed (see Preset Speed #1 for
further information on this parameter).							Minimum — Lower Limit
							Maximum — Upper Limit
							Units — Hz
Preset Speed #14
Program		Preset Speeds			14		Parameter Type — Numerical
This parameter assigns an output frequency to binary number 1110 and is							Factory Default — 0.00
identified as Preset Speed #14. The binary number is applied to S1 – S4 of the							Changeable During Run — Yes
Control Terminal Strip to output the Preset Speed (see Preset Speed #1 for
further information on this parameter).							Minimum — Lower Limit
							Maximum — Upper Limit
							Units — Hz
Preset Speed #15				⇒
	⇒
Program		Preset Speeds			15		Parameter Type — Numerical
This parameter assigns an output frequency to binary number 1111 and is							Factory Default — 0.00
identified as Preset Speed #15. The binary number is applied to S1 – S4 of the							Changeable During Run — Yes
Control Terminal Strip to output the Preset Speed (see Preset Speed #1 for
further information on this parameter).							Minimum — Lower Limit
							Maximum — Upper Limit
							Units — Hz
Preset Speed Mode Control
	⇒			⇒
Program		Preset Speeds			Mode		Parameter Type — Selection List
Enables/Disables the use of the Preset Speed Mode control for Preset Speeds							Factory Default — Disabled
1 – 15.							Changeable During Run — No
The Preset Speed Mode control setting determines if the Speed setting only is
used (disabled) or if the user-set combinations of the Torque, Speed, Accel/
Decel, and Direction settings will be used (enabled) while running Preset
Speeds 1 – 15.
Proportional (P) Gain
Program	⇒Feedback Settings⇒					Proportional Gain	Parameter Type — Numerical
This parameter determines the degree that the Proportional function affects the							Factory Default — 0.10
output signal when using PID feedback to control the ASD output. The larger							Changeable During Run — Yes
the value entered here, the quicker the ASD responds to changes in feedback.
	⇒			⇒			Minimum — 0.01
							Maximum — 100.0
W7 ASD Installation⇒			and Operation Manual⇒				103