RX2 Speed Reference Setpoint #1 |
|
|
|
| RX2 Speed Reference Setpoint #2 | |||
|
|
|
| |||||
RX2 Speed Reference Setpoint #1 |
|
|
| |||||
Program |
| Frequency Settings |
| Speed Reference Setpoints |
| RX2 | Parameter Type — Numerical | |
RX2 Speed Reference Setpoint #1 |
|
| Factory Default — 0.00 | |||||
|
|
|
|
|
|
| ||
This parameter is used to set the direction, gain, and bias of the RX2 input | Changeable During Run — Yes | |||||||
terminal when the RX2 terminal is used as the control input while operating in | ||||||||
| ||||||||
the Speed Control or the Torque Control mode. |
|
| Minimum — | |||||
See RX2 Speed Frequency Setpoint #1 for further information on this setting | Maximum — 100.0 | |||||||
when used for Speed control. |
|
|
|
| ||||
|
|
|
|
| ||||
See RX2 Torque Reference Setpoint #1 for further information on this setting | Units — % | |||||||
| ||||||||
when used for Torque control. |
|
|
|
|
| |||
This parameter sets the RX2 input level that is associated with RX2 Speed |
| |||||||
Frequency #1 when operating in the Speed control mode and is associated with |
| |||||||
the RX2 Torque Reference Setpoint #1 when operating in the Torque control |
| |||||||
mode. |
|
|
|
|
|
|
| |
This value is entered as |
| |||||||
signal range. |
|
|
|
|
|
| ||
|
|
|
| |||||
RX2 Speed Reference Setpoint #2 |
|
|
| |||||
Program | ⇒ | Frequency Settings | ⇒ | Speed Reference Setpoints | ⇒ | RX2 | Parameter Type — Numerical | |
⇒ |
|
|
|
| ||||
RX2 Speed Reference Setpoint #2 | ⇒ |
|
| |||||
| ⇒ |
| ⇒ |
|
| Factory Default — 0.00 | ||
This⇒parameter is used to set the direction, gain, and bias of the RX2 input | Changeable During Run — Yes | |||||||
terminal when the RX2 terminal is used as the control input while operating in |
| |||||||
the Speed Control or the Torque Control mode. |
|
| Minimum — |
See RX2 Speed Frequency Setpoint #1 for further information on this setting | Maximum — 100.0 | |
when used for Speed control. | ||
| ||
See RX2 Torque Reference Setpoint #1 for further information on this setting | Units — % | |
| ||
when used for Torque control. |
| |
This parameter sets the RX2 input level that is associated with RX2 Speed |
| |
Frequency #2 when operating in the Speed control mode and is associated with |
| |
the RX2 Torque Reference Setpoint #2 when operating in the Torque control |
| |
mode. |
| |
This value is entered as |
| |
signal range. |
|
114 | W7 ASD Installation and Operation Manual |