Toshiba W7 manual RX Speed Reference Setpoint #1, RX Speed Reference Setpoint #2

RX Speed Reference Setpoint #1							RX Speed Reference Setpoint #2
RX Speed Reference Setpoint #1
Program		Frequency Settings		Speed Reference Setpoints		RX	Parameter Type — Numerical
Speed Reference Setpoint #1							Factory Default — 0.00
This parameter is used to set the direction, gain, and bias of the RX input							Changeable During Run — Yes
terminal when the RX terminal is used as the control input while operating in
the Speed Control or the Torque Control mode.							Minimum — -100.0
See RX Speed Frequency Setpoint #1 for further information on this setting							Maximum — 100.0
when used for Speed control.
See RX Torque Reference Setpoint #1 for further information on this setting							Units — %
when used for Torque control.
This parameter sets the RX input level that is associated with RX Speed
Frequency Setpoint #1 when operating in the Speed control mode or is
associated with the RX Torque Reference Setpoint #1 when operating in the
Torque control mode.
This value is entered as -100 to +100% of the -10 to +10 VDC RX input signal
range.
RX Speed Reference Setpoint #2
Program	⇒	Frequency Settings	⇒	Speed Reference Setpoints	⇒	RX	Parameter Type — Numerical
range.
Speed Frequency Setpoint #2			⇒		⇒
	⇒						Factory Default — 100.00
This parameter is used to set the direction, gain, and bias of the RX input							Changeable During Run — Yes
terminal when the RX terminal is used as the control input while operating in
the Speed Control or the Torque Control mode.							Minimum — -100.0

See RX Speed Frequency Setpoint #1 for further information on this setting	Maximum — 100.0
when used for Speed control.
See RX Torque Reference Setpoint #1 for further information on this setting	Units — %
when used for Torque control.
This parameter sets the RX input level that is associated with RX Speed
Frequency Setpoint #2 when operating in the Speed control mode or is
associated with the RX Torque Reference Setpoint #2 when operating in the
Torque control mode.
This value is entered as -100 to +100% of the -10 to +10 VDC RX input signal

W7 ASD Installation and Operation Manual 117