![](/images/new-backgrounds/1264344/264344123x1.webp)
ASD Wait Time |
|
|
|
| Base Frequency #1 | ||
|
|
|
|
|
| ||
ASD Wait Time |
|
|
|
|
| ||
Program | Special Control |
| Inverter Wait Time | Parameter Type — | |||
This parameter determines the amount of time that the drive will wait before | Factory Default — | ||||||
| |||||||
outputting a signal to the motor once the | Changeable During Run — No | ||||||
been met. |
|
|
|
|
| ||
|
|
|
|
|
| ||
|
|
|
|
|
| ||
ASD Typeform |
|
|
|
|
| ||
Program | Utilities Version |
| ASD Type | Parameter Type — | |||
This parameter is | Factory Default — | ||||||
| |||||||
the ASD. |
|
|
|
|
| Changeable During Run — No | |
⇒⇒ |
|
| |||||
|
|
| |||||
Autotune Control Setting |
|
|
| ||||
Program ⇒Motor Settings | Autotune Control Setting | Parameter Type — Selection List | |||||
When enabled via the Autotune Enable parameter, this parameter sets the | Factory Default — Disabled | ||||||
| |||||||
Autotune command status. |
|
|
| Changeable During Run — No | |||
|
|
|
|
|
| ||
Settings: |
|
|
|
|
|
| |
(Autotune) Disabled |
|
|
|
| |||
Reset (Motor) Defaults |
|
|
|
| |||
Enable (Autotune) on Run Command |
| ||||||
|
|
|
|
|
| ||
Autotune Enable |
|
|
|
|
| ||
Program | Motor Settings | Autotune Enable | Parameter Type — Selection List | ||||
This parameter Enables/Disables the Autotune function. | Factory Default — Enabled | ||||||
|
| ⇒ |
| ⇒ |
| Changeable During Run — No | |
Base Frequency #1 |
|
|
|
| |||
Program ⇒Motor Settings ⇒Base Frequency #1 | Parameter Type — Numerical | ||||||
The Base Frequency setting determines the frequency at which the output | Factory Default — 60.0 | ||||||
| |||||||
voltage of the ASD reaches its maximum setting. The maximum voltage setting | Changeable During Run — Yes | ||||||
cannot be more that the input voltage⇒ | (see the Maximum Output Voltage #1 | ||||||
| |||||||
parameter). There are four Base Frequency profile settings: #1 – #4. | Minimum — 25.0 | ||||||
Note: For proper motor operation, the Base Frequency is | Maximum — 299.0 | ||||||
normally set for the | Units — Hz | ||||||
|
|
|
|
|
|
56 | W7 ASD Installation and Operation Manual |