
BIN Speed Frequency Setpoint #1 | BIN Speed Frequency Setpoint #2 |
BIN Speed Frequency Setpoint #1
Program Frequency Settings | Speed Reference Setpoints | BIN |
⇒ | ⇒ | ⇒⇒ |
BIN Speed Frequency Setpoint #1 |
|
This parameter is used to set the direction, gain, and bias of the discrete input terminals when using the discrete input terminals as the control input while operating in the Speed Control mode.
BIN Input Speed/Direction Control Setup
Perform the following setup to allow the system to receive Speed control input at the discrete input terminals:
• | Program | Utilities Command Mode Terminal Block. |
• | Program | Utilities ⇒Frequency Mode ⇒Use Binary/BCD Input. |
• | Program ⇒Terminal Settings Input Terminals; select and set the | |
| desired discrete input terminals to Bin Bit(s) 0 – 7 or 0 – MSB (see table | |
| Table 6 on page 138 for a listing of the available terminal settings). The | |
| binary terminal input word will control the direction, speed, and torque of | |
| the motor. |
|
• Provide a Run command (F and/or R). |
• Set BIN Speed Frequency #2,⇒and
Speed/Direction Control
Perform the following setup to allow the system to perform Speed control from the BIN input terminals:
• Set BIN Speed Frequency #1,
• Set the binary input value (% of 255D) (BIN Speed Ref #1) that represents
BIN Speed Frequency #1,
• Set the binary input value (% of 255D) (BIN Speed Ref #2) that represents the BIN Speed Frequency #2.
Note: 255D is the decimal equivalent of the
Once set, as the BIN input word changes, the directional information and the output frequency of the ASD will vary in accordance with the above settings.
This parameter sets BIN Speed Frequency #1 and is the frequency that is associated with the setting of BIN Speed Reference 1.
Parameter Type — Numerical
Factory Default — 0.0
Changeable During Run — Yes
Minimum —
Maximum — 80.0
Units — Hz
Frequency Settings
BIN Speed Frequency Setpoint #2
Program Frequency Settings Speed Reference Setpoints BIN
BIN Speed Frequency Setpoint #2
This parameter⇒is used to set the direction,⇒gain, and bias of the discrete⇒⇒input terminals when using the discrete input terminals as the control input while operating in the Speed Control mode.
See BIN Speed Frequency Setpoint #1 for further information on this setting.
This parameter sets BIN Speed Frequency #2 and is the frequency that is associated with the setting of BIN Speed Reference 2.
58
Parameter Type — Numerical
Factory Default — 80.0
Changeable During Run — Yes
Minimum —
Maximum — +80.0
Units — Hz
W7 ASD Installation and Operation Manual